Canon ScanFront 300 Instructions Manual page 185

Password is incorrect.
There is no file name specified.
Enter a file name or enable the
'Auto file name' setting.
Log in failed. Settings may
currently be in the process of
being edited via the Web.
Log in failed. A version upgrade
may currently be in the process
of being executed.
Cannot write logfile. Sending
files will be aborted.
You can't use following
character for File name.
The character string includes
invalid character.
Not enough memory to execute
current scanner settings. Please
see "Troubleshooting" section at
"INSTRUCTIONS" or "Operation
Guide".
Log in failed. A version
Password may be changed.
Log in failed. Authentication
server is not found.
Cause The password that was entered is incorrect.
Solution
Enter the uppercase and lowercase letters for the password correctly.
Cause A file name was not entered and "Auto file name" is set to [None].
Enter a file name or set "Auto file name" to other than [None].
Solution
p. 5-34.)
Cause User settings are being edited via the Web menu.
Solution
Contact the administrator of the ScanFront.
Cause The version of the ScanFront is being updated via the Web menu.
Solution
Contact the administrator of the ScanFront.
Write permission has not been granted for the shared folder specified as
Cause
the save destination of the log file.
Solution Check the settings and access permissions of the shared folder.
Cause
Invalid characters have been used to set the customer file name.
Make sure the custom file name does not contain any of the following
Solution
characters:
/ : ? * " < > |
Cause
Invalid characters have been used to set the index file.
Make sure none of the following characters are used in strings
Solution contained in the index file:
& " ' < >
There was not enough memory available for the set scanning
Cause
conditions.
Reset the scanning conditions. Refer to "Not enough memory to
Solution
execute scanner settings" below.
User password was changed on the authentication server while server
Cause
authentication and fingerprint authentication are both used to log in.
Without using fingerprint authentication, enter your user name and
Solution
changed password to log in, and then re-register your fingerprints.
The user specified when logging in does not exist in the authentication
Cause
server.
Make sure you correctly enter your user name and password. Contact
Solution
the administrator of the ScanFront if this problem persists.
10-7
Chapter 10 Troubleshooting
(See