Adjusting The Multicontour Seat - Mercedes-Benz CLS Operator's Manual

reduce the potential for injury to the head and
neck in the event of an accident or similar sit-
uation.
Whenever the rear seats are occupied, only
drive the vehicle with the head restraints
installed and engaged. Head restraints are
intended to help reduce injuries during an
accident.
Adjusting the rear seat head restraint
angle
Pull or push the top of the head restraint until
X
it is in the desired position.
Removing and installing the rear seat
head restraints
G
WARNING
If the head restraints are not installed or not
adjusted correctly, they cannot provide pro-
tection as intended. There is an increased risk
of injury in the head and neck area, e.g. in the
event of an accident or when braking.
Always drive with the head restraints instal-
led. Before driving off, make sure for every
vehicle occupant that the center of the head
restraint supports the back of the head at
about eye level.
!
Make sure that the rear window roller sun-
blind has been retracted before the rear head
restraints are removed. You could otherwise
damage the roller sunblind.
The head restraints can only be removed if the
rear seat folds forward.
To remove: press release catch : and pull
X
the head restraint out of the guides.
To re-install: insert the head restraint so that
X
the notches on the bar are on the left when
viewed in the direction of travel.
Push the head restraint down until you hear it
X
engage in position.

Adjusting the multicontour seat

The multicontour seat function is only available
for vehicles in Canada.
To adjust the thigh cushion
:
To adjust the backrest contour in the lumbar
;
region
To adjust the backrest contour in the upper
=
back region
To adjust the side bolsters of the seat back-
?
rest
You can adjust the contour of the front seat
individually so as to provide optimum support
for your back and sides.
I n f o r ma t i o n P r o v i d e d b y :
Seats
97
Z