Adjusting The Multicontour Seat - Mercedes-Benz CLS Operator's Manual

Seats
102
Adjusting the rear seat head restraint
angle
Pull or push the top of the head restraint
X
until it is in the desired position.
Removing and installing the rear seat
head restraints
G
WARNING
If head restraints are not installed and
adjusted correctly, they cannot provide
protection as intended. There is an increased
risk of injury in the head and neck area, e.g.
in the event of an accident or when braking.
Always drive with the head restraints
installed. Before driving off, make sure for
every vehicle occupant that the center of the
head restraint supports the back of the head
at about eye level.
! Make sure that the rear window roller
sunblind has been retracted before the rear
head restraints are removed. You could
otherwise damage the roller sunblind.
To remove: pull the head restraint up to
X
the stop.
Press release catch : and pull the head
X
restraint out of the guides.
To re-install: insert the head restraint so
X
that the notches on the bar are on the left
when viewed in the direction of travel.
Push the head restraint down until you hear
X
it engage in position.

Adjusting the multicontour seat

The multicontour seat function is only
available for vehicles in Canada.
To adjust the thigh cushion
:
To adjust the backrest contour in the
;
lumbar region
To adjust the backrest contour in the
=
upper back region
To adjust the side bolsters of the seat
?
backrest
You can adjust the contour of the front seats
individually so as to provide optimum support
for your back and sides.
Turn the SmartKey to position 2 in the
X
ignition lock ( page 147).
Y