Removing/Installing The Valve - Regency Bellavista B36XTCE Owners & Installation Manual

maintenance
|
60
REMOVING VALVE
1) Shut off the gas and electrical supply.
2) Remove the mesh barrier.
3) Open the flush door and remove the door.
4) Remove the logs.
5) Remove the burner/grate assembly by
removing the 2 Phillips head screws.
Diagram 1: Remove the left and right screws.
6) Slide the burner assembly to the left to release
it from the orifice, then lift it out.
Orifice
Diagram 2: Slide burner assembly to the left
and then remove.
7) Remove the 2 screws securing the rear log
tray and lift out. Diagram 3
Diagram 3
60 |
Bellavista ®
B36XTCE-10 Gas Fireplace
8) Disconnect the inlet gas line.
9) Disconnect the EV1, EV2, and ground wires
from the valve - as shown below.
Diagram 4
EV1
10) Remove the 8 Phillips head screws securing
the valve tray assembly in place (Diagram
5) and then lift the entire assembly out
(Diagram 6).
Diagram 5
Diagram 6
INSTALLING VALVE
1) Place new valve tray into position
EV2
2) Reinstall the 8 hold down screws.
3) Hook up the 2 TP and 2 TH wires to the ap-
propriate connections on the valve.
4) Reinstall the rear log tray.
5) Install burner/grate assembly
6) Hook up the gas line and check for gas leaks
with a soap and water solution or a gas leak
detector. (Do not use open flame for leak
testing.)
7) Fire up the unit temporarily
8) Check the manifold pressure.
9) Reinstall the logs and brick panels as needed.
10) Reinstall the door and replace the louvers.
11) Fire up the unit again and check for proper
flame appearance and glow on logs.
Diagram 8