Port Property - Planet EPL-2000 User Manual

4.2.10 Port Property

In Port Property you can configure the settings of each port to control the connection parameters, and the status of each port is
listed below:
The popup window includes the following fields:
Object
Port ID:
Mode Config:
Flow Control Config:
Port VID:
swPortvlanmode:
Figure 4-32 Port Property Screen
Description
This is the logical port name for this row.
Select any available link mode for the given EPL-2000 fiber port. Draw the menu
bar to select the mode.

Auto - Setup Auto negotiation for copper interface.

Copper-1000BASE - Force sets 1000Mbps/Full-Duplex mode.

Fiber-1000BASE - Force sets 1000Mbps/Full-Duplex mode.
Whether or not the receiving node sends feedback to the sending node is
determined by this item. When enabled, once the device exceeds the input data
rate of another device, the receiving device will send a PAUSE frame which halts
the transmission of the sender for a specified period of time.
When disabled, the receiving device will drop the packet if too much to process.
Allows to assign PVID for selected port. The range for the PVID is 1-4094.
The PVID will be inserted into all untagged frames entering the ingress port. The
PVID must be the same as the VLAN ID whose port belongs to VLAN group, or
the untagged traffic will be dropped.
Allows user to modify the VLAN mode, there are two modes:
59
User's Manual of EPL-2000