Husqvarna TE 250R 2013 Operation And Maintenance page 34

ADJUSTING THE FORK
a) COMPRESSION (TXC: LOWER REGISTER; TE: UPPER REGISTER)
Standard calibration : -9 clicks (TXC);
Standard calibration : -12 clicks (TE)
To reset to the standadr calibration turn register (A) clockwise
until the position of fully closed is reached then, turn back by the
mentioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
a)
D
b) EXTENSION (TXC: LOWER REGISTER; TE: UPPER REGISTER)
Standard calibration : -8 clicks (TE);
Standard calibration : -13 clicks (TXC).
To reset to the standard calibration turn register (C) clockwise
to reach the position of fully closed; then, turn back by the
mentioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
- AIR VENT (to carry out after each competition, or monthly).
Set the motorcycle on a central stand and release the fork fully
and loosen the air vent valve (D). Once this operation is over,
tighten the valve.
WARNING: Never force the adjusting screws
beyond the maximum opening and closure
positions.
TXC b)
C
A
NOTE
Flexibility index for the serial springs:
K=4,6 N/mm
NOTE
Always replace both the spring and the spacers to keep the
preload value unchanged.
a)
TXC b)
SPECIFICATIONS - OPERATION - MAINTENANCE
A
C
TE
TE
D
EN - 33