To General Users; Notice To Users - Toshiba e-studio 2802a Safety Information Manual

.
When connecting this product with an outer network such as the Internet, only operate it in a
network environment protected by a firewall, etc. to prevent information from being leaked
due to incorrect settings or avoid illegal access by unauthorized users.
To prevent the configuration settings from being altered improperly or similar, before you use
this product, change the administrator password set by factory default. Also, be sure
periodically to change each password set for this product.
In order to make proper use of the network function and the department management
function, be sure to read the TopAccess Guide and User's Guide first.
Be sure to understand the security policy and its procedure in your organization, and manage
and operate this equipment according to the policy after first reading the operator's manual.
Then explain the security instructions to general users who are authorized to use this
equipment to let them conform to the security rule.
Provide general users with the appropriate privilege of using this equipment and keep
supervising its correct operation.
Always check if the network function or the department management function is enabled in
order to maintain security. Should you happen to come across any abnormality, contact your
service technician immediately. Refer to the TopAccess Guide and User's Guide for the
checking method.

To general users

After you have finished operating the equipment, be careful not to forget to remove any
originals, printed paper or USB storage devices.
Change the password regularly. Make sure not to use any predictable number such as your
birthday or employee ID number, and keep it secret.
Do not leave the equipment during the performance of the job since your originals may be
seen or the output paper could be taken by someone.

Notice to Users

After a suitable place has been selected for the installation of the e-STUDIO2802A/2802AM/
2802AF, or the e-STUDIO2309A/2809A, please do not change it. Avoid excessive heat, dust,
vibration and direct sunlight. Also, provide proper ventilation as the copier emits a small
amount of ozone.
The unit is classified as Class 1 Laser Product according to IEC60825-1:2007 including
amendments.
The unit uses laser diodes with a max. output of 5 mW, a wavelength of 785 nm, pulse
duration 1.25 µs.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
WARNING
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
Safety Information 5 (GB)
GB