Table of Contents
Advertisement
VLI31 Fireplace Insert
BLOWeR RePLAceMeNt
Turn off the unit and allow to cool completely. Turn off gas
at shut-off and disconnect all electricity to unit.
1. Remove the decorative filigree by gently pulling it out.
. Rotate the cam on the glass toward the center.
3. Tilt the glass out, lift and release it from the track.
4. Set the glass on a towel out of the way.
5. Remove the logs and bricks. To remove the brick,
unfasten the brackets located on the right and left.
6. Unfasten the brick support plate fastened to the
burner.
Brick Panels
36
Light Box
Brick Support
Andirons
Glass Door
Assembly
BLOWeR ReMOVAL and ASSeMBLy
7. Remove light box by removing the screw in front of
the light box and pull up and over to the left out of the
way.
8. Unfasten the rectangular plate located at the rear of the
firebox by only removing the six (6) screws around the
perimeter of the plate.
9. Lift the plate up and slide to the left. You may have to
rotate the plate to clear the blower through the hole.
10.Disconnect the two () wires to free the blower.
11.Reassemble the blower in reverse order.
Blower Assembly
Fettle
Figure 43 -
Blower Removal and Assembly
FP1963
83D4009
Advertisement
Table of Contents
