Table of Contents
Advertisement
VeNtING INStALLAtION
INtAKe MANIFOLD VeNt INStALLAtION
Before insert is placed back into fireplace opening, attach
intake flex pipe to intake manifold, located in rear lower left
corner with hose clamp (not supplied) or other approved
method.
exhAuSt MANIFOLD ReMOVAL AND VeNt
INStALLAtION
The exhaust manifold is shipped attached to insert. It may
be removed to allow tight installation.
1. Remove glass door assembly following instructions on
Page 39, Figure 54.
. Lightly tap on flange of exhaust baffle assembly towards
you until disengaged. Remove baffle, manifold and
gasket from unit. Figure 9
Front View
Gasket
Side View
Figure 9 -
Remove Manifold and Attach to Flex Vent
83D4009
FP1960
manifold assembly
Flex Vent
9/08
Manifold
Baffle
Assembly
FP1960
3. Attach the slotted baffle plate. Figure 10
4. Feed exhaust flex through hole on top of insert and
attach to manifold with hose clamp (not provided) or
other approved methods (check local codes). Insure
the gasket is in place before securing the flex to the
manifold.
NOte: Sealant is not required to assemble fireplace
venting. Do not use silicone sealant at the inner flue
exhaust connections.
5. Re-attach exhaust baffle and manifold assembly in
reverse order of Step .
6. Re-attach glass door in reverse order.
NOte: The VLIDV has an adjustable baffle and may be
adjusted as needed by loosening four (4) screws. Figure
10.
Loosen Four (4) Screws to Adjust
Bottom View
closed Position
Adjust for extended vertical applications if needed.
FP1961
baffle adjustment
Figure 10 -
9/08
Baffle Plate
VLI31 Fireplace Insert
Bottom View
Open Position
13
Advertisement
Table of Contents
