Table of Contents
Advertisement
R E M O T E
Ending Remote Access Call
Press *, 9. The system announces "The
machine will now hang up," and
disconnects from the line.
Changing Your
Remote Access Code
1
Connect with the answering
system.
Press and release 9, 9. The system
2
beeps once.
3
Enter your new Remote Access Code
(any number between 500 and 999
except for the Priority Calling Code).
4
If a valid code is entered, the system
announces the new Remote Access
Code. If an invalid code is entered,
the system beeps five times rapidly,
then beeps twice. Repeat Steps 2
and 3.
Turn System Off
1
Connect with the answering
system.
Press 8, 8, then hang up.
2
Turn System On
When the system is off, it answers after 10
rings and beeps twice.
Press 0 to turn the system on.
1
2
The system beeps twice and is ready
to answer calls and record messages.
If the system beeps five times, the
memory is full.
O P E R A T I O N
Memory Full
If the system answers after 10 rings and
beeps twice instead of playing your
announcement, the system is off, memory
is full, or the AO announcement is
selected but not recorded.
1
Enter your Remote Access Code after
the two-beep signal.
Press 7, 1 to check your
2
announcement. If you hear no
announcement, press 7, * to record
a new announcement.
3
Listen to messages, and delete some
or all of them.
Press 0 to make sure your system is
4
on before you hang up.
Voice Help Menu
The Voice Help Menu allows you to use
several system features from a remote
location even when you cannot remember
the touch tone commands. All you need
to know is your Remote Access Code, and
the system will prompt you. As soon as
you hear the command you need, press
the appropriate buttons.
Hide quick links:
Advertisement
Table of Contents
