Overload Protection (Subaru/Robin-Powered Units) - Miller Electric Bobcat 225 Owner's Manual

8-7. Overload Protection (Subaru/Robin-Powered Units)

2
.
Fuses F1, F2 located on
bracket behind left side
panel.
Tools Needed:
3/8 in
Notes
OM-4434 Page 38
.
Fuse F6 located in
1
harness behind left
side door.
3
.
A complete Parts List is available at www.MillerWelds.com
!
1
F1 protects the weld excitation
winding from overload. If F1 opens,
weld output stops or is low.
2
F2 protects the generator power
excitation winding from overload. If
F2 opens, generator power output
stops or is low.
3
F6 protects the engine wiring sys-
tem from overload. If F6 opens,
engine will not crank.
Replace any open fuses. Reinstall
cover before operating.
NOTICE − If a fuse opens, it usually
indicates a more serious problem
exists. Contact a Factory Autho-
rized Service Agent.
MATERIAL THICKNESS REFERENCE CHART
24 Gauge (.025 in)
22 Gauge (.031 in)
20 Gauge (.037 in)
18 Gauge (.050 in)
16 Gauge (.063 in)
14 Gauge (.078 in)
1/8 in (.125 in)
3/16 in (.188 in)
1/4 in (.25 in)
5/16 in (.313 in)
3/8 in (.375 in)
1/2 in (.5 in)
Stop engine. Disconnect
negative (−) battery cable.
Fuse F1 (See Section 11-1)
Fuse F2 (See Section 11-1)
Fuse F6 (See Section 11-1)
803 848-C