Adjusting Engine Speed (Kohler-Powered Units) - Miller Electric Bobcat 225 Owner's Manual

9-5. Adjusting Engine Speed (Kohler-Powered Units)

5
4
1
3
Top View
.
A complete Parts List is available at www.MillerWelds.com
2200 − 2300 rpm
(36.6 − 38.3 Hz)
3675 − 3750 rpm
(61.3 − 62.5 Hz)
2
After tuning engine, check engine
speeds with a tachometer (see
table). If necessary, adjust speeds
as follows:
Start engine and run until warm.
Turn Fine Control to 10.
Remove rear panel and air cleaner
to access idle speed adjustments.
Remove top cover to access weld/
power speed adjustments.
Idle Speed Adjustment
Move Engine Control switch to
Run/Idle position.
1 Throttle Solenoid
2 Mounting Screws
3 Idle Speed Screw
Loosen mounting screws. Adjust
solenoid position so engine runs at
idle speed. If necessary, back out
idle speed screw so solenoid can
be moved to correct position. Tight-
en mounting screws. Be sure sole-
noid linkage works smoothly.
Turn idle speed screw for fine ad-
justments.
Weld/Power Speed Adjustment
Move Engine Control switch to Run
position.
4 Weld/Power Speed
Adjustment Nut
5 Lock Nut
Loosen lock nut. Turn adjustment
nut until engine runs at weld/power
speed. Tighten lock nut.
!
Stop engine.
Reinstall air cleaner, rear panel,
and top cover.
Tools Needed:
1/4, 3/8 in
803 849 / 801 209-A
OM-4434 Page 43