Section 4 − Maintenance And Troubleshooting; Maintenance Schedule; Overload Protection - Miller Electric Belt/Hydraulic-Driven Generator Owner's Manual

SECTION 4 − MAINTENANCE AND TROUBLESHOOTING

4-1. Maintenance Schedule

1/2 in.
(13 mm)

4-2. Overload Protection

OM-4414 Page 8
Every 250 h
Check Belt
Tension
(Belt-Driven
Models Only)
Every 500 h
Service Welding Generator
Brushes And Slip Rings. Service
More Often In Dirty Conditions.*
Y Stop engine before maintaining.
.
Service more often if used in severe conditions.
* To be done by Factory Authorized Service Agent.
Replace
Unreadable
Blow Out Inside Of
During Heavy Service,
Clean Monthly.
Y Stop engine.
.
When a circuit breaker opens,
it usually indicates a more seri-
ous problem exists. Contact
Factory Authorized Service
Agent.
Open cover to access generator.
1 Circuit Breaker CB1
CB1 protects the generator wind-
ings from overload. If CB1 opens,
generator output stops.
Close covers before operating unit.
1
Labels.
Generator.
803 233