Table of Contents
Advertisement
Attach the viewfinder.
3
After confirming that the camera is off,
slide the signal contact into the multi-
accessory port until it latches.
s
D
Handling the Viewfinder
Remove the viewfinder when it is not in use. If the viewfinder is
attached, the shocks and vibration to which the camera may be
exposed during transport or when placed in a bag could damage the
camera or viewfinder. To remove the viewfinder, confirm that the cam-
era is off and then press and hold the latch release buttons while
detaching the viewfinder from the multi accessory port.
Do not touch the viewfinder signal contact. Failure to observe this pre-
caution could cause product malfunction.
A
Using the Viewfinder
Use the viewfinder when bright ambient lighting conditions make it
difficult to see the display in the monitor. When you put your eye to
the viewfinder, the eye sensor will turn the viewfinder on and the
monitor off (note that the sensor responds to more than just your eyes;
when using the monitor, keep your fingers and other objects from the
sensor). You can also use the display-selection button to cycle through
display settings as follows: automatic display selection (Eye sensor
on); viewfinder on, monitor off (Eye sensor off ); and monitor on, view-
finder off. The eye sensor is re-enabled automatically each time the
camera is turned on. While the viewfinder is on, you can use the $
button to view or hide indicators (0 5).
A
Viewfinder Focus
If you find that the icons and other indica-
tors displayed in the viewfinder seem blurry,
rotate the diopter adjustment control until
the display is in sharp focus. When operating
the control with your eye to the viewfinder,
be careful not to put your fingers or finger-
nails in your eyes.
28
Advertisement
Table of Contents
