Problem Solving Guide - Miele CS 1212-1 Operating And Installation Instructions

Problem solving guide

With the aid of the following guide, minor problems can be easily corrected
without contacting Miele.
If having followed the suggestions below, you still cannot resolve the problem,
please contact Miele (see end of this booklet for contact details).

Danger of injury. Installation, maintenance and repairs may only be carried
out by a suitably qualified and competent person.
Repairs and other work by unqualified persons could be dangerous. Miele can-
not be held liable for unauthorised work.
Do not attempt to open the casing of the CombiSet yourself.
Problem
The cooking zones do
not heat up.
A smell and vapours are
given off when the new
appliance is being used.
 is flashing in a cook-
ing zone display.
36
Cause and remedy
There is no power to the hob.
 Check if the mains fuse has tripped. If it has, con-
tact a qualified electrician or Miele (minimum fuse
rating - see data plate).
There may be a technical fault.
 Turn the cooking zone control to 0.
 Disconnect the appliance from the electricity sup-
ply for approx. 1 minute. To do this:
– switch off at the isolator, or
– disconnect the mains fuse.
 If, after resetting the trip switch in the mains fuse
box and switching the appliance back on, the ap-
pliance will still not heat up, contact a qualified
electrician or Miele.
The metal components have a protective coating.
When the appliance is used for the first time, this
causes a smell and possibly also vapour. The material
from which the induction coils are made also gives off
a smell in the first few hours of operation. This smell
will be less noticeable with each subsequent use be-
fore dissipating completely. The smell and any vapour
given off do not indicate a faulty connection or appli-
ance and they are not hazardous to health.
There is no pan on the cooking zone, or the pan is un-
suitable.
 Use a suitable pan (see "Pans").