Problem Solving Guide; Messages In The Display - Miele KM 7999 FR Operating And Installation Instructions

Problem solving guide

Many malfunctions and faults that can occur in daily operation can be easily
remedied. You can save time and money in many cases, as you do not need to call
the Miele Customer Service Department.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or
a fault and to resolve it.

Messages in the display

Problem
The touch display indic-
ates or
F6713 F6771
the hob switches off
automatically.
The touch display indic-
ates F6734 and the hob
switches off automatic-
ally.
The touch display indic-
ates F6716 and the hob
switches off automatic-
ally.
The touch display indic-
ates F6704 and the hob
switches off automatic-
ally.
A message not listed in
this table is appearing
in the display.
62
Cause and remedy
Empty cookware has been heated.
and
 Touch
OK
 Wait until the residual heat indicator  goes out
(see "Operation – Residual heat indicator").
 Make sure that you have placed ingredients in the
cookware.
The cookware is incorrectly positioned.
 Position the cookware correctly (see "Operation –
Positioning cookware").
 Touch
OK
The touch display is covered, e.g. by finger contact,
food boiling over or an object.
 Clean off any soiling and/or remove the object (see
"Safety features – Safety switch-off").
 Touch
OK
The vents used to cool the hob are blocked.
 Remove anything that may be blocking the vents.
 Touch
OK
There is an electronic module fault.
 Disconnect the power supply to the hob for ap-
prox. 1 minute.
 If the problem persists after the power supply has
been restored, please contact the Customer Ser-
vice Department.
.
.
.
.