Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Messages in the display
Issue
In the cooking zone
display, the symbol
will flash alternately
with the selected power
level or .
After the hob has been
switched on appears
in the timer display for a
few seconds.
After the hob has been
switched on appears
in the timer display
briefly. The cooking
zones do not heat up.
flashes in the timer
display and the hob
switches off
automatically.
will flash alternately
with in the timer
display.
will flash alternately
with , or in the
timer display.
Cause and remedy
An unsuitable pan has been placed on the hob.
Use suitable pans (see "Pans" in the "Induction"
chapter).
The system lock or safety lock is activated.
Deactivate the system lock or safety lock (see
"System lock / Safety lock").
The hob is in demonstration mode.
Touch the 0 and 2 sensor controls at the same
time until flashes alternately with in the timer
display.
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
Clean off any dirt and/or remove the object (see
"Safety switch-off").
The overheating protection mechanism has been
activated.
See "Safety features – Overheating protection".
The fan is blocked or defective.
Make sure it has not been blocked by an object.
Remove the obstruction.
If this fault message continues to appear in the
display, contact your Miele dealer.
Problem solving guide
51