Step 5: Installing Anti-Tip Device - Thermador PROFESSIONAL PRO GRAND PRG364JDG Installation Manual

To Check Door Fit and Adjustment:
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. Do not force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. The range must be level for proper alignment of the
oven doors, see "Step 9: Placing and Leveling the
Range".
3. If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
4. For 48" models with large and small ovens, if door or
handle appears slightly tilted, you may adjust the hinge
receiver by rotating the large Torx-head screw located
directly above the hinge receiver with a T-20 Torx
driver. Rotate each screw respective to its side and
direction the door needs to be adjusted (Figure 10).
Figure 10: Hinge Receiver Adjustment Screw
English 12
Step 5: Installing Anti-Tip
Device
For all ranges, an anti-tip device must be installed as per
these instructions.
WARNING:
RANGE TIPPING HAZARD:
— All ranges can tip and injury can result.
To prevent accidental tipping of the
range, attach it to the floor by installing
the Anti-Tip Device supplied.
— A risk of tip-over may exist if the
appliance is not installed in accordance
with these instructions. For all ranges an
anti-tip device must be installed.
— A child or adult can tip the range and be
killed.
— Do not operate the range without the anti-
tip device in place and engaged. Failure
to do so can result in death or serious
burns to children or adults.
If the range is pulled away from the wall for cleaning,
service or for any other reason, ensure that the Anti-Tip
Device is properly re-engaged when the range is pushed
back against the wall. In the event of abnormal usage
(such as a person standing, sitting, or leaning on an
open door), failure to take this precaution can result in
tipping of the range. Personal injury might result from
spilled hot liquids or from the range itself.
ATTENTION — PROPERTY DAMAGE:
• Contact a qualified installer or contractor to determine
the proper method for drilling holes through the wall or
floor material (such as ceramic tile, hardwood, etc.)
• Do not slide the range across an unprotected floor.
• Failure to follow these instructions may result in
damage to wall or floor coverings.
Tools Needed for Installation of Anti-Tip Device:
• Screwdriver, Phillips
• Drill
• 1/8" drill bit (wood or metal; wall or floor)
• 3/16" carbide-tipped masonry drill bit (concrete or
concrete block wall or floor)
• 3/16" anchors, drywall or concrete, 4 each (not
required if mounting bracket is being attached to solid
wood or metal)
• Measuring tape