Moving The Range - Thermador PROFESSIONAL PRO GRAND PRG364JDG Installation Manual

3. The grates, griddle plate, burner caps, and oven racks
must be removed to facilitate handling. Do not remove
the griddle element and tray assembly.
Shipping Weight
Weight without packing
materials
Without door(s), burner caps,
and oven racks

Moving the Range

CAUTION:
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly.
Due to the weight, it is strongly recommended that a
furniture dolly with soft wheels or an air lift should be used
to move this unit. The weight must be supported uniformly
across the bottom.
All ranges are held to the pallet by (4) bolts through a wood
block center. The two front pallet bolts are accessible only
after removing the Door Trim located beneath the doors.
1. Remove the door trim by loosening the 2 Torx screws
attaching it to the range. Slide the trim up and off the
screws.
Figure 6: Door Trim, Packing Blocks, & Pallet Bolts
English 10
36" 48"
Range Range
420 lbs 590 lbs
(191 kg) (268 kg)
360 lbs 530 lbs
(163 kg) (240 kg)
260 lbs 390 lbs
(118 kg) (177 kg)
Table 2: Range Weight
2. To remove the pallet bolts use (2) ½" (13 mm)
wrenches, one to hold bolt at the bottom while the other
is loosening the nut at the top. Discard the wood
packing block inserts.
Figure 7: Removal of Shipping Bolts
3. Carefully tilt the range back on the casters and remove
it from the pallet. Use additional help as required to
remove from pallet.
4. After transporting the range by dolly close to its final
location, the range can then be tipped back and
supported on the rear casters while the dolly is
carefully removed.
5. Use the casters to assist with the installation near to its
final location. THE FLOOR UNDER THE LEGS
SHOULD BE PROTECTED BEFORE PUSHING THE
UNIT INTO POSITION.
• Steps 5 through 8 must be completed before the
range is placed in its final position.