Adjusting Control Tilt Bracket; Installing Boom And Reel Support - Miller Electric Swingarc SS-75D16 Owner's Manual

4-2. Adjusting Control Tilt Bracket

4-3. Installing Boom And Reel Support

4
5
6
1
Tools Needed:
3/8, 3/4 in
OM-230 298 Page 10
1
2
3
3
7
2
1 Tilt Bracket
2 Rear Pivot Screw
3 Front Screw
Loosen rear pivot screw. Remove
front screw. Pivot control down-
ward to desired viewing angle. Re-
place and tighten front screw. Tight-
en pivot screw.
803 155
1 Swivel Plates
2 Yoke
Remove hardware from swivel
plates and yoke.
3 Boom
Set boom into swivel as shown.
4 Yoke Pin
Install pin through yoke. Install cot-
ter pin and spread ends.
5 Bolt
Install bolt, tighten hardware, and
back bolt off one half turn.
6 Locking Knob
Install locking knob but do not
tighten.
7 Reel Support
Install reel support.
ST-142 596-C