Adjusting Engine Speed (Honda-Powered Units) - Miller Electric 185 Owner's Manual

8-3. Adjusting Engine Speed (Honda-Powered Units)

Tools Needed:
1/4, 3/8 in
2
1
4
3
.
Complete Parts List available at www.MillerWelds.com
After tuning engine, check engine
speeds. See table for proper no
load speeds. If necessary, adjust
speeds as follows:
1400 150 rpm
Start engine and run until warm.
Weld/Power Speed
Adjustment
3750 30 rpm (62 Hz)
1 Throttle Control Lever
2 Adjustment Screw
Move lever to Run (far left) position.
Turn screw and move lever until en-
gine runs at weld/power speed.
Idle Speed Adjustment
3 Pilot Screw
4 Throttle Stop Screw
Move lever to idle (far right) posi-
tion. Turn pilot screw until engine
runs at highest idle speed. Turn
stop screw until engine runs at
rated idle speed (normally about
2-1/4 turns out.)
!
Stop engine. Close fuel
valve.
803 597−B / Ref. 802 101-A
OM-4415 Page 29