Installing 4 In (102 Mm) Wire Spool And Adjusting Hub Tension - Miller Electric M-10 Gun Owner's Manual

4-12. Installing 4 in (102 mm) Wire Spool And Adjusting Hub Tension

3
2
1
.
For units prior to serial no. LG160043N, order 2 nylon washers (p/n 228 771)
and spring (p/n 225 256) to install the 4 in. (102 mm) wire spool.
4
2
1
3
Tools Needed:
Removing 8 in (203 mm) Spool Components
6
5
4
4
Installing 4 in (102 mm) Wire Spool
3
Rotate brake adjust knob until
a slight force is needed to turn
spool, then tension is set.
1 Hub Nut
2 Brake Adjust Knob
3 Spring
4 Nylon Washer
5 Spool Hub
6 Brake Washer
Remove brake adjust knob and
spring, and nylon washer.
Remove and retain hub nut, spool
hub, and brake washer.
1 Brake Adjust Knob
2 Spring
3 Nylon Washer
4 4 in (102 mm) Wire Spool
Install 4 in (102 mm) wire spool
using spool components as shown.
804 629-A
OM-1328 Page 19