Table of Contents
Advertisement
Item
System, Power,
c
SD Indicators
Reset Button
d
GND
e
Power Port
f
Network Port
g
I/O Port
h
Video Out Port
i
RS-485 port only supports direct connection with pan/tilt driver and external connections of the
J
`
RS-485 controller is not supported.
ON : While the power is on
POWER
OFF : If the power is off
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Used for earth-grounding.
Used to plug the power cable.
Used to connect a PoE or LAN cable.
ALARM OUT
Used to connect the alarm output signal.
ALARM IN
Used to connect the alarm input signal.
ALARM COM Common port where the alarm output signal is connected.
GND
Used for earth-grounding.
RS-485+
RS-485 Data line
RS-485-
RS-485 Data line
Analog video output port. (for installation)
Description
English _13
Advertisement
Table of Contents
