Basic Navigation Modes; Effect Button Array Overview - dbx DriveRack 260 User Manual

Section 2
Editing
Functions

2.1 Basic Navigation Modes

Navigational aspects of the 260 DriveRack is simple and as follows. 1. FX buttons - This array
of 12 FX buttons is your primary mode of directly accessing any effect module. 2. NEXTPG
& PREVPG page buttons - Successive presses of the NEXTPG or PREVPG page buttons will
move the user from one page to the next in an effect block. 3. Data Wheel - The Data Wheel
is used to move through the program menu of the 260 DriveRack. The Data wheel is also used
to change the values of the selected parameter by simply rotating the wheel. Pressing the Data
wheel will toggle between the available parameters on any selected page of the currently
selected effect module.

2.2 Effect Button Array Overview

PREVIOUS PAGE - Moves to the previous page in the currently selected
effect menu.
NEXT PAGE - Moves to the next page in the currently selected effect menu.
EQ - Selects the EQ effect menu. This is the EQ section located prior to the
crossover section.
crossover 28 band EQ and Post-xover PEQ section modules.
XOVER - Selects the Crossover section.
OTHER - This button is used to move to the module insert section module
which includes the Notch filter, Subharmonic Synthesizer, AFS (Advanced
Feedback Suppression) and Wire (no parameters) modules.
DYNAMICS - Selects the Dynamics effect sections.
Successive presses will move from the Compressor, Gate and AGC (pre-xover)
to the AGC and Limiter (post-xover).
DELAY - Selects the Alignment Delay effect module. successive presses will
rotate through the Pre and post Delay modules.
I/O - Selects the input and output parameter editing section for all inputs and
outputs. Successive presses will move through each input and output.
PROGRAM (Config) - This button is used to enter the Program screen
from any sub section within the unit when pressed. When pressed and
held, you will enter Config mode.
UTILITY(Meter) - Selects the Utility menu of the 260 DriveRack. When
pressed and held, the 260 will enter METER mode.
14 DriveRack™ User Manual
Editing Functions
Successive presses will rotate through the various pre-
DriveRack
®
™