Millivolt Control Lighting Instructions - Vermont Castings VWF18 Installation And Operating Instructions Manual

VWF Series Vented Gas Log Set

MILLIVOLT CONTROL LIGHTING INSTRUCTIONS

1. STOP! Read the safety information label.
2. Make sure the manual shutoff valve is fully open.
3. Turn gas control knob clockwise
4. Wait (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell
gas, STOP!
5. From "OFF" position, turn the gas control knob counterclockwise
in control knob for 5 seconds.
6. With the control knob pushed in, light pilot with match.
7. Continue pushing the control knob in for a further 60 seconds to prevent the flame detector from
shutting off the gas while the probe is warming up. Release the control knob.
8. Turn gas control knob counterclockwise
9. After the pilot has been lit for one minute, the burners can be turned on. Turn the ON/OFF switch
to "ON" position.
10. If the gas logs will not operate, follow the instructions To Turn Off Gas To Heater and call your
service technician or gas supplier.
Pilot
1. Turn control knob clockwise
2. If applicable: Turn ON/OFF switch to OFF position.
44
to the "OFF" position, and turn ON/OFF switch to "OFF" position.
O N
TO TURN OFF GAS TO HEATER
to OFF position to completely shut off the heater.
OPERATING INSTRUCTIONS FOR MVVk kITS
to the "ON" position.
O F
F
Control Knob
to "PILOT" position. Push
on/off Switch
LG908
on off switch
27D8520