Table of Contents
Advertisement
Conneci'img
23
,,-
@
Note
• WEP security
mode generally
have 4 keys
available on an access point setting. If your
access point or wireless router
useWEP
security, enter the security code of:the key
"No.l"to
connect
on your home network.
• An Access Point is a device that allows you
to connect
to your home network
wirelessly.
4.
Use A / V / < / > to select the IP mode
between
[Dynamic]
and [Static].
Normally,
select [Dynamic]
to allocate
an IP
address automatically.
-- @
Note
If:there is no DHCP server on the network
and
you want to set the IP address manually,
select
[Static] then set [IP Address], [Subnet
Mask],
[Gateway] and [DNS Server] using A / V /
</>
and numerical
buttons.
If:you make a
mistake while entering
a number,
press CLEAR
to clear the highlighted
part.
5. Select [Next] and press ENTER (®) to apply
network
settings.
Network
connection
status is displayed
on the
screen.
6. Select [OK] and press ENTER (®) to complete
the network
connection.
Advanced
Setting
El:you want to set the network settings manually,
use A / V to select [Advanced Setting] on the
[Network Setting] menu and press ENTER (®).
1. Use A / V to select [Wireless] and press ENTER
(®).
[AP List] - Scans all available
access points or
wireless touters within
range and display them
as a list.
[Network
name (SSID)] -Your
access point
may not be broadcasting
its network
name
(SSID). Check your access point settings
through
your computer
and either set your access
point to broadcast
SSED,or manually
enter the
network
name in [Network
name(SSID)].
[PBC] - If:your access point or wireless
router that supports the PBC (Push Button
Configuration)
method,
select this option
and
press the Push Button on your access point
within
120 counts.You
do not need to know the
network
name (SSID) and security
code of:your
access point.
[PIN] -If:your
access point supports
the PIN
Code conf:iguration
method
based on WPS(Wi-
Fi Protected
Setup), select this option
and
note the code number
on the screen. And
then, enter the PIN number
on a setting
menu
of:your access point to connect.
Ref:er to the
documentation
f:or your network
device.
2. Follow the instructions
of: each connection
method
on the screen.
Note
use PBC and PIN network
connection,
ecurity
mode of:your access point must be
et to OPEN or AES.
©
o
Advertisement
Table of Contents
