Wired Network Setup - LG SoundPlate LABS40W Owner's Manual

Cor_necfir_g 21
Wired network setup
ffthere is a DHCP server on the local area network
(LAN) via wired connection, this player will
automatically be allocated an EPaddress. After
making the physical connection, a small number of
home networks may require the player's network
setting to be adjusted. Adjust the [NETWORK]
setting as follow.
I Preparation
Before setting the wired network, you need to
connect the broadband internet to your home
network.
1. Select [Connection Setting] option in the
[Settings] menu then press ENTER (®).
Advanced Setfing
If you want to set the network settings manually,
use A / V to select [Advanced Setting] on the
[Network Setting] menu and press ENTER (®).
1. Use A / V to select [Wired] and press ENTER
(®).
Use A / V / < / > to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an EP
address automatically.
©
o
Read the preparations for the network settings
and then press ENTER (®) while [Start] is
highlighted.
Network will automatically be connected to the
unit.
.- @
Note
If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using A / V /
</> and numerical buttons. If you make a
mistake while entering a number, press CLEAR
to clear the highlighted part.
Select [Next] and press ENTER (®) to apply
network settings.
Network connection status is displayed on the
screen.
Press ENTER (®) while [OK] is highlighted to
finish the wired network settings.