Mx-Te10 (Exit Tray Unit); Parts Included; Installation - Sharp MX-M354N Installation Manual

[8] MX-TE10 (EXIT TRAY UNIT)

MX-M264U
1.

Parts included

Paper exit unit Paper exit tray
Harness cover OP
Screw (M3 x 4) Screw (M4 x 10)
2.

Installation

NOTE: Turn off the main switch of the machine and then remove
the power plug of the machine from the outlet.
1) Remove two EPE cushions.
2) Remove five screws and remove the rear cabinet.
Paper holding arm
Paper exit Right paper
right cover exit actuator
Screw (M3 x 8)
MX-M264U MX-TE10 (EXIT TRAY UNIT) 8 – 1
Service Manual
3) Remove two screws and remove the right cabinet unit.
NOTE: One of the removed screws is used in the step 6).
4) Insert the harness of the right paper exit unit to the hole of the
second paper exit.
NOTE: Wire the harness to the upper of the rib.
If wiring it to the under of the rib, the harness may
come into contact with the gear.
5) Insert the pawl of the right paper exit unit to the oval hole of the
frame of the main unit.
Insert the positioning boss of the main unit to the round hole in
lower side.
6) When tightening the screw, tighten in the sequence of (1), (2),
(3) and (4).
2
2
1 1 1
Rib
Gear
3
1
4