Mx-Ds16/Ds17 (Low Stand/High Stand); Unpacking; Installation - Sharp MX-M354N Installation Manual

[6] MX-DS16/DS17 (LOW STAND/HIGH STAND)

MX-M264U
1.

Unpacking

Unpack the package, and check to confirm that all the parts are
provided.
Machine stand
MX-DS17
Packed parts
Front adjusters: 2 pcs.
( 110)
Copier connecting fixtures: Screws (S tight):
2 pcs. 2 pcs.
Packed parts add
MX-DS16
Adjuster covers: 2 pcs.
Screws (P tight):
4 pcs.
MX-M264U MX-DS16/DS17 (LOW STAND/HIGH STAND) 6 – 1
Service Manual
2.

Installation

1) Attach the adjusters.
Attach the front adjusters (2 pcs.) as shown in the figure below.
Rear side
Screw the adjusters into
the hole so that the adjuster
tips do not extend out from
the hole.
2) Attach the adjuster covers.
Put the desk on the floor in the normal state, and open the
door.
Slide the adjuster covers (2 pcs.) as shown in the figure below
and attach them. Then, close the door.
MX-DS17
Front side
Adjuster covers
MX-DS16
Front side
Adjuster covers
3) Remove the paper tray.
Pull out the paper feed unit tray from the copier until it stops.
Lift it and remove it from the copier.
Front
adjuster
( 110)
Front
adjuster
( 110)
Front side