Canon iR1020 Series Service Manual page 59

7) Secure the repeating harness A [1] with the wire saddle [2].
8) Remove the two blind cover [1] from the reader left cover.
[1]
9) Using the two supplied TP screws (M4x16) [1], attach the card reader to
the reader.
10) Route the repeating harness B [2] in the hole [3] of the right cover.
When tightening the screws, take care not to damage the repeating harness A.
[2]
[1]
F-2-15
F-2-16
[1]
[2]
[3]
F-2-17
11) Slide the card reader cover [1] to attach it to the card reader mount.
Route the repeating wire A [1] as shown below.
12) Using the supplied binding screw (M4x6)[1], secure the card reader cov-
er [2].
13) Connect the connector of the repeating harness A [1] to the connector
J317 [2] on the image processor PCB.
[2]
Chapter 2
[1]
F-2-18
[1]
F-2-19
[2]
[1]
F-2-20
[1]
F-2-21
2-5