Introduction; Installing The Stand Or Wall-Mount Bracket; Installing The Stand; Installing A Wall-Mount Bracket - Insignia NS-L19X-10A User Manual

Introduction

Congratulations on your purchase of a high-quality
Insignia product. Your NS-L19X-10A represents the
state of the art in LCD TV design and is designed for
reliable and trouble-free performance.
Installing the stand or
wall-mount bracket

Installing the stand

To install the stand:
1 Carefully place your TV screen face-down on a
cushioned, clean surface to protect the screen
from damages and scratches.
2 Secure the stand to the screen with the two
included screws.
3 To remove the stand from the TV, perform these
steps in reverse order.

Installing a wall-mount bracket

If you want to attach your TV to a wall-mount
bracket (not provided), you must first remove the
stand column.
To remove the stand column:
1 Lay your TV face down on a table or bench.
Make sure that you put down a soft cushion or
cloth so that your TV does not get scratched.
2 Remove the two screws holding the stand
column to your TV, then remove the stand
column.
Note
The appearance of the product in these instructions
may differ from your actual product, and is for
comparative purposes only.
To attach your TV to a wall-mount bracket:
Warning
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of hazards,
do not perform any servicing other than that
contained in the operating instructions unless you
are qualified to do so.
1 Remove the stand column.
4
Stand
Screws
www.insigniaproducts.com
2 Secure the wall-mount bracket to the back of
your TV using the four M4 screws provided with
bracket.

Adjusting the viewing angle

To adjust the viewing angle:
• Adjust the angle forward 5° to back 10°.
Caution
When adjusting the angle, be careful not to tip the
TV.
Replacing the decorative
faceplate

Replacing the decorative faceplate

To replace the faceplate:
1 Carefully pull the decorative faceplate off your
TV.
-5 o
10 o