Table of Contents
Advertisement
MICROBOARDS TECHNOLOGY, LLC
4. Test+Copy
With the Test + Copy menu option, the autoloader simulates the copying process, and then makes copies if
everything works correctly. If a failure is encountered on a disc during the simulation, it will not be copied
during the copying process while the discs that passed the simulation will move on to the copying process.
After the copying process, the autoloader will place the failure discs into the reject area while the successfully
copied discs will be placed into the corresponding Output Spindle.
Operation in Test+Copy menu is identical to operation in Copy menu.
5. Copy+Compare
The Copy + Compare menu option is used to make verified copies. After the copy process is done, the
autoloader automatically compares the copies to the master content residing in the hard drive to ensure that
they are identical. When the operation is complete, the autoloader automatically places good discs on to the
Output Spindle and bad discs in the Reject Area.
Operation in Copy+Compare menu is identical to operation in Copy menu.
6. Select Burn Speed
The Select Burn Speed menu option is used to adjust the duplication speed for the various duplication modes.
By default, the duplication speed will be set to the optimal speed. However, under some circumstances you
might want to lower the duplication speed. Those circumstances are:
Poor Blank Media Quality - When your media quality is sub-par, lowering the duplication speed is
necessary to make good copies.
Duplication Quality - Overall, the lower the speed, the higher the quality of your duplicates. If you
have time, it is a good choice to lower the speed to produce the best quality duplicates.
If you are at the 1. Copy Menu, do the following:
Microboards B.30
1. Copy
(MM)
Microboards B.30
6. Select Burn Speed
Select Burn Speed
HDD to CD Speed
Depending upon the type of duplication and your autoloader restrictions, you need to select the correct format
in order to take effect. To select the recording speed options, use the
desired speed for the appropriate format and press the
similar to this:
HDD to CD Speed
32x
The options that are available are shown in Table 2-1.
Duplication Type
HDD
Speed
HDD
Speed
These options might change depending on the CD or DVD writers pre-installed in your system.
Note: The speed that you choose may be adjusted by the drives and/or the media for optimized
duplication.
19
Use the
Up or
Down button to find the 6. Select Burn Speed menu.
Press the
OK button on 6. Select Burn Speed menu to set the duplication
burn speed and you will see the Select Burn Speed type menu similar to
below:
There are two recording speed types that can be set:
HDD to CD: Copy Hard Drive CD Content to CD-R/RW Discs speed.
HDD to DVD: Copy Hard Drive DVD Content to DVD±R/RW Discs.
Use the
Up or
Down button to find the desired speed. Press the
button to set the desired recording speed.
Speeds Available
to
CD
1x, 2x, 4x, 8x, 12x, 16x, 24x, 32x, 40x, 48x,
52x
to
DVD
1x, 2x, 2.4x, 4x, 6x, 8x, 12x, 16x
Table 2-1 Duplication Speeds
Up or
OK button to enter the menu. You will see a menu
HCL Series
Down buttons to find the
OK
Advertisement
Table of Contents
