Test & Copy; Verify - MicroBoards Technology QD-DVD 123 User Manual

Test & Copy
The Test and Copy function will perform both operations, one after the other. If the Test portion
passes without errors, the system will automatically start the Copy process.
To run the Test and Copy function, press the ▼▲ buttons until the display reads:
3. Test & Copy
Place your master disc into the DVD reader drive.
Place your blank media into the DVD recorder drives.
Press the ENT button on the controller interface.
The duplicator will now simulate writing to the blank discs.
Testing – 16x 48%
2.3GB 03:15
When this operation completes, the unit will start the Copy process:
Copying – 16x 48%
2.3GB 03:15
When the job is completed, the recorded discs will be ejected from the recorder drives.
The display will read:
3.0 Copy
OK: 07

Verify

The Verify function will check to see if the recorded discs can be read. This is different from the
Compare function. The Verify function will not compare itself with the master disc. It is only
checking to see if the discs that were recorded can be read back.
To run the Verify function, press the ▼▲ buttons until the display reads:
4. Verify
Place the copied discs into the DVD recorder drives.
Press the ENT button on the controller interface.
The copied discs will now be read. Once completed, the display will show:
4. Verify
OK: 07
9