Chevrolet Impala 2016 Owner's Manual page 275

274 Vehicle Care
3. Remove the bulb socket by
turning counterclockwise and
pulling straight out.
4. Remove the bulb from the
socket by pulling it straight out.
5. Install the new bulb in the bulb
socket.
6. Install the bulb socket by
turning clockwise.
7. Install the trunk deck trim.
Stoplamp/Taillamp/Turn Signal
Lamp and Back-Up Lamp
Driver Side Shown, Passenger
Side Similar
1. Back-Up Lamp
2. Stoplamp/Taillamp/Turn
Signal Lamp
Caution
Improper lamp assembly removal
and installation can cause leaks
and water intrusion which may
cause damage to the taillamp. Do
(Continued)
Caution (Continued)
not remove the taillamp assembly
to replace a bulb. Use the trunk
opening to access the bulb.
To replace one of these bulbs:
1. Open the trunk. See Trunk
0 41.
2. Remove the push pins and pull
the trunk trim away from the
taillamp assembly.
3. Remove the bulb socket from
the taillamp assembly by
turning it counterclockwise.
4. Remove the bulb from the
socket by turning the bulb
counterclockwise one-quarter
turn and pulling it straight out.
5. Install a new bulb into the
socket.
6. Install the bulb socket into the
taillamp assembly by turning it
clockwise.
7. Install the trunk trim and
push pins.