Overview; Initial Operation - Metabo MAG 28 LTX 32 Original Instructions Manual

Keep the handles dry, clean and free of oil and
grease.
Caution! The use of other tools and accessories
can result in a risk of injury.
Use the handle (2) on the magnetic drill stand
when transporting the machine.
Always wear a safety harness when
working on scaffolds.
Wear ear protectors.
Wear protective goggles.
Danger - magnetic field.
Persons with pacemakers prohibited.
4.1 Safety instructions for battery packs:
Protect battery packs from water and
moisture!
Do not expose battery packs to naked
flame!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short-circuit battery packs!
Slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks
out and comes into contact with your eyes, wash
them with clean water and seek medical attention
immediately.
Remove the battery pack from the machine before
any adjustments, conversions or servicing are
performed.
Before fitting the battery pack, make sure that the
machine is switched off.

5 Overview

See page 3 (please unfold).
1 Magnet block/Magnet
2 Handle
3 Supply cock on cooling lubrication unit
4 Container for cooling lubrication unit
5 Threaded pins for adjusting backlash of the
side plate
6 Lock switch to prevent the machine from
moving up/down accidentally
7 Slide plate
8 Switch (switching on/off driving unit)
9 Electronic signal indicator
10 Thumbwheel (1st /2nd gear)
11 Slot in machine neck for driving out tools
12 Removal tool (MK 2) *
13 Drill spindle with tool attachment (MK 2)
14 Anti-twist device
15 Tool holder threaded pins*
16 Tool holder (Weldon, 19 mm) *
17 Quick-action coupling of the cooling lubri-
cation unit
18 Battery pack
19 Two buttons for battery-pack release
20 Button for capacity and signal indicator
21 Capacity and signal indicator
22 Lever for moving driving unit up and down
23 Shaft
24 Display of magnet holding power
25 Ratchet switch lever (activate/deactivate
magnet)
26 Ratchet lever (activate/deactivate magnet)
27 Ratchet on securing strap
28 Securing strap
29 Two holding points
* depending on equipment/not in scope of delivery

6 Initial Operation

Check the machine for possible damage:
Before using the machine, you must carefully
check protective devices or slightly damaged
components to ensure they are operating perfectly
and as intended. Check that moving parts are in
perfect working order and do not jam and check
whether parts are damaged. All parts must be
correctly installed and fulfil all conditions neces-
sary to ensure perfect operation of the grinder.
Damaged protective devices and parts must be
repaired or replaced according to specifications
by an authorised specialist workshop.
6.1 Battery pack
Charge the battery pack before use (18).
If performance diminishes, recharge the battery
pack.
ENGLISH
ENG
13