Use - Metabo MAG 28 LTX 32 Original Instructions Manual

ENGLISH
ENG
The ideal storage temperature is between 10°C
and 30°C.
Li-ion battery packs Li-Power (25.2 V) have a
capacity and signal display (21):
- Press button (20) and the charge level is
displayed by the LEDs .
- If one LED is flashing, the battery pack is almost
flat and must be recharged.
- If all LED are flashing, the battery pack is too
warm. Allow the battery pack to cool down. You
can do this quickly using ASS 15 Plus battery
charger.
6.2 Removing and inserting the battery
pack
Removal:
Press both battery pack release buttons (19) and
take out battery pack (18).
Inserting:
Slide in the battery pack (18) until it engages.

7 Use

7.1 Attaching the Securing Strap
For drilling carried out on angled and vertical
surfaces and overhead, the magnetic drill
stand must be secured with the securing strap
(28)supplied to prevent it from falling, even if the
magnet malfunctions.
Fit the securing strap (28) so that the
magnetic drill stand is moved away from the
operator if the magnet malfunctions.
Replace the securing strap (28) if it has had
to catch a falling magnetic drill stand.
Caution! Check the securing strap (28) for
damage. Before using the securing strap
(28), always check it carefully to ensure it is oper-
ating faultlessly and as specified. If the securing
strap (28) is damaged or if the ratchet (27) is no
longer working properly, replace the securing
strap immediately.
- Fit the securing strap (28) on one of the two
holding points (29) of the magnetic drill stand.
- Then secure the securing strap to another suit-
able fastening point or to the material being
processed.
14
(a)
- Notes on the securing strap (28):
Insert the free end of the securing strap from
below through the opening in the ratchet shaft
and then tension the free end of the securing
strap until it is loosely fitted.
The strap must not be tightly fitted: you
must be able to unroll the securing strap
by more than one rotation about the ratchet
shaft - This is essential to ensure secure
fastening. Tension the securing strap with a
pumping action on the ratchet lever (a).
- Ensure that the securing strap is guided to be
taut in position.
- Check that the strap connection is secure.
The securing strap does not replace the
magnetic force of the magnetic drill stand: it
is simply used to secure against falling in the event
of a magnet malfunction.
To loosen the securing strap:
Caution: the tension is released in sudden
bursts! To loosen the securing strap, open
the ratchet fully and simultaneously use your
finger to pull the locking strap (b) upward.
7.2 Cooling Lubrication Unit for Core Drill-
ing
The tool life depends on the lubrication. Lubri-
cating the inside of the core drill bit with high-
performance cutting oils is essential for core
drilling.
To fill with oil, remove the container (4) from
the magnetic drill stand.
Fill the container with high-performance cutting oil
(4) and close the screw cap. Switch the lubrication
on or off at the supply cock (3).
For work carried out on vertical and overhanging
surfaces or overhead surfaces (and when storing
the unit in the case), the container (4) must be
emptied or removed to prevent liquid from
escaping (otherwise there is a risk of cutting oil
entering the motor and causing a short-circuit).
When carrying out this type of task, spray the
inside of the cutting edge tool before drilling with
universal cutting spray (see chapter 10 Accesso-
ries). Repeat the process several times for larger
drilling depths.
(b)