Overview; Special Product Features; Commissioning - Metabo STEB 70 Quick Operating Instructions Manual

Follow national requirements for the materials you
want to work with.
During work, the workpiece must lay flat and be
secured against moving, e.g. using clamps.
Do not try to saw extremely small workpieces.
When sawing, the footplate must make secure
contact with the workpiece.
When interrupting a cut for any reason, release the
trigger and hold the saw motionless in the material
until the saw blade comes to a complete stop.
Never attempt to remove the saw from the work-
piece while the saw blade is in motion or kickback
may occur.
Do not switch the machine on while the saw blade
is touching the workpiece. Let the saw blade reach
full speed before making a cut.
When restarting a saw in the workpiece, centre the
saw blade in the kerf and check that saw teeth are
not engaged into the material. If the saw blade
seizes, it may kickback from the workpiece when
the saw is restarted.
Keep hands well away from the sawing area and
the saw blade. Do not reach underneath the work-
piece.
Remove chips and similar material only with the
machine at standstill.
Pull the plug out of the socket before making any
adjustments, converting or servicing the machine.
Danger of injury due to the sharp jigsaw blade.
After stopping work, the jigsaw blade may still be
hot. Wear protective gloves.
SYMBOLS ON THE TOOL:
.............. Class II Construction
V.................. volts
A.................. amperes
Hz................ hertz
W................. watts
~
................. alternating current
n ................ stroke rate at idle speed
0
spm............. stroke rate per minute

4 Overview

See page 3 (please unfold).
1 Clamping lever for securing the saw blade
2 Saw blade support roller
3 Saw blade
4 Screw for adjusting the footplate
5 Footplate
6 Switch button on the chip blower
7 Adjustment lever for pendulum motion
8 Anti-splintering footplate insert
9 Protective cap
10 Saw blade clamping fixture
11 Protective rod for preventing unintentional
contact with the saw blade
12 Setting wheel for speed adjustment
13 Trigger
14 Lock button for continuous activation
15 Hexagon spanner
16 Extractor connection piece
17 Curved support plate indicating preset cutting
angle

5 Special Product Features

• Metabo quick-release saw blade without key

6 Commissioning

Before plugging in, check to see that the
rated mains voltage and mains frequency, as
stated on the rating label, match your power
supply.
Never operate the machine without a saw
blade.
Pull the plug out of the plug socket before any
adjustments, conversions or servicing are
performed.
6.1 Fitting the anti-splintering footplate
insert
Danger of injury due to the sharp jigsaw
blade. Remove the saw blade before fitting
(8) the anti-splintering footplate insert.
Turn the machine over so that the footplate faces
upwards. Insert the anti-splintering footplate from
the front, ensuring the following:
• The smooth side of the footplate faces upwards.
• The slot is facing to the rear (towards the mains
cable).
If you wish to work with the protective plate
attached (see chapter Accessories 10), fit the
anti-splintering footplate insert in the protective
plate..
6.2 Inserting the saw blade
Danger of injury due to the sharp jigsaw
blade. After stopping work, the jigsaw blade
may still be hot. Wear protective gloves.
Use a saw blade that is suitable for the material
being sawn.
ENGLISH
ENG
7