Troubleshooting - Bissell powerlifter 1576 series User Manual

Troubleshooting

Problem
Vacuum
cleaner won't
turn on
No power at
brush roll
Vacuum
cleaner won't
pick up dirt
Visible dirt
escaping
from cleaner
Please do
not return
this product
to the store.
www.BISSELL.com
10
Possible causes
Power cord not plugged in
Blown fuse/tripped breaker
Hand Vacuum is not securely
connected to extension wand
Switch is not in correct position.
Brush roll is not properly installed.
Debris stuck on the brush roll
or belt.
Brush roll wear or damage.
Belt wear or damage.
Rotating floor brush bristles worn
Rotating floor brush jammed
Clog in vacuum
Dirt container full
Cyclone assembly not installed
properly
Filters are dirty
Dirt container full
Filters or separator not installed
correctly
Dirt container lid is not closed
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
For any questions or concerns, BISSELL is happy to be
of service. Contact us directly at 1-800-237-7691.
WARNING
To reduce the risk of electric shock,
turn power switch off and disconnect
polarized plug from electrical outlet
before performing maintenance or
troubleshooting checks.
Remedies
Check electrical plug
Check/replace fuse or reset breaker
Remove hand vacuum and replace,
making sure it clicks into place.
Make sure brush switch is in "ON"
position
Remove the brush roll and install the
brush as shown on page 11.
Clean the brush roll or belt.
Purchase a new brush roll.
Call BISSELL Consumer Care at
1-800-237-7691 to purchase a
new foot.
Replace brush
Remove brush and clean debris
from brush ends
Follow instructions on page 11 for
clearing clogs
Empty dirt container
Position correctly and lock in place
Check and clean filter
Empty dirt container
Check separator and filter for correct
installation
Firmly press the dirt container lid
to close until you hear a click