Assembly; Operations; Attach Handle To Vacuum - Bissell powerlifter 1576 series User Manual

Assembly

No tools required for assembly.

Attach handle to vacuum

1. Connect Extension Wand to Power
Foot nozzle.
2. Connect Hand Vacuum to the
Extension Wand.
NOTE: You can change what tools attach to
the hand vacuum and extension wand.
3. To remove the tool, grasp the two grey
colored buttons and squeeze to release the
lock. Pull up to remove the tool.
4. To attach the tool, align the grooves of the
tool to the guides on the nozzle and push into
place until you hear a click.
3.

Operations

Cleaning your floors
This vacuum has 2-Speed Brush Roll control.
1. Slide the POWER switch up to the first
position to clean bare floors and delicate
area rugs. (In the first position, the brush
roll spins slowly.)
2. Slide the POWER switch up to the second posi-
tion to clean carpeted areas. In the
second position, the brush roll spins faster
to help pickup debris below the surfaces.
(Recommended for carpeted areas and thick
area rugs.)
Removing dusting tool
from extension wand
1.
4.
Attaching dusting tool
to hand vacuum
CAUTION
Before using your vacuum,
make sure that the dirt
container is in locked posi-
tion and that all filters are in
place. Do not operate your
vacuum without these filters.
1.
OFF 1st Position
Low Brush
Roll
www.BISSELL.com
2.
2.
2nd Position
High Brush
Roll
5