Bissell powerlifter 1576 series User Manual page 9

Maintenance & Care
8. When cleaning is complete, put your brush
roll back into foot nozzle.
9. Align the drive belt slots to the end of the
brush roll that also has slots.
NOTE: You may have to stretch the belt in order
to securely align the brush roll to the belt.
10. Once the belt and brush roll slots are aligned,
secure the brush roll into the foot nozzle slots.
11. When correctly re-assembled, you will be able
to turn the brush roll with your fingers smoothly.
12. Put the brush cover locks back into place. Use
a small coin or flat head screwdriver to turn back
into lock position.
Clearing Clogs
1. Unplug the vacuum from electrical outlet.
2. Disconnect the hand vacuum from the
extension wand.
3. Check the hand vacuum dust inlet openings
for clogs or blockages.
4. Disconnect the power foot from the
extension wand.
5. Check the extension wand for clogs or
blockages.
6. Check the power foot dust inlet for clogs
or blockages.
7. Proceed to check connection parts for
clogs or blockages.
8. Clear all clogs or blockages if required.
Storage
Use the wall mount to conveniently store
your vacuum.
NOTE: A Phillips Head Screwdriver is need to
install the wall mount. If installing onto drywall,
use plastic anchors before you screw into place.
1. Place the wall mount against the wall in the
area where you've determined you would like
to store your vacuum.
2. Place 1 screw into top hole. Use a screwdriver
or drill to affix to wall/
3. Repeat with second screw in bottom hole.
4. Find the opening on the bottom of the
hand vacuum and hook it on the hanger on
the wall mount.
NOTE: If the wall mount is not used, the
vacuum should be stored in a safe place, in
the upright position against a firm surface
to prevent falling over.
www.BISSELL.com
9