Default Settings - Metrologic MS6200 Pulsar Installation And User Manual

A B
PPENDIX

Default Settings

Many functions of the scanner can be "programmed" – that is, enabled or disabled. The
scanner is shipped from the factory programmed to a set of default conditions. The default
parameter of the scanner has an asterisk (*) in the charts on the following pages. If an
asterisk is not in the default column then the default setting is OFF or DISABLED. Every
communication does not support every parameter. If the communication supports a
parameter listed in the charts on the following pages, a check mark will appear.
Parameter
Normal Scan Mode (Blink)
Continuous Scan Mode
UPC/EAN
UPC-A
EAN-8
EAN-13
UPC-E
Code 128
Code 93
Codabar
Interleaved 2 of 5 (ITF)
MOD 10 check on ITF
Code 11
Code 39
Full ASCII Code 39
Telepen
Matrix 2 of 5
Airline 2 of 5 (13)
Airline 2 of 5 (15)
Dual Codabar
DK Plessey
STD 2 of 5
MSI Plessey
Double Border
Small Border
MOD 43 Check on Code 39
MSI-Pessey 10/10 Check
Digit
MSI-Plessey MOD 10
Check Digit
Paraf Support ITF
Default OCIA
*
*
*
*
*
*
*
*
*
*
*
*
Light
RS-232
Pen
As Code
39
As Code
39
IBM
KBW
46XX
21