Default Settings - Communication Parameters - Metrologic MS1633 FocusBT Installation And User Manual

D S
EFAULT ETTINGS
Many functions of the scanner can be "configured" – that is, enabled or disabled.
The scanner is shipped from the factory configured to a set of default conditions.
The default parameter of the scanner has an asterisk (*) in the charts on the
following pages. If an asterisk is not in the default column then the default setting
is OFF or DISABLED.
PARAMETER
Multi-Try Trigger Out-of-Stand
Presentation Mode In-Stand
Continuous Trigger
Single Trigger
Aiming in
Trigger and Continuous Modes
Aiming in Presentation Mode
Long-Range In-Stand
Short-Range In-Stand
Long-Range Out-of-Stand
Short-Range Out-of-Stand
RangeGate Mode
Inventory Mode
UPC/EAN
Code 128
Code 93
Codabar
Interleaved 2 of 5 (ITF)
MOD 10 check on ITF
Code 11
Code 39
Full ASCII Code 39
PDF
– C
OMMUNICATION
DEFAULT
*
*
*
*
*
*
*
*
*
*
*
*
P
ARAMETERS
PARAMETER
Data Matrix
QR Code
Maxicode
Aztec
Postals
Mod 43 Check on Code 39
MSI-Plessy 10/10 Check Digit
MSI-Plessy Mod 10 Check Digit
Paraf Support ITF
ITF Symbol Lengths
Symbol Length Lock
Beeper tone
Beep/transmit sequence
Communication timeout
Razzberry tone on timeout
Three beeps on timeout
Same symbol rescan timeout:
1000 msecs
Same symbol rescan timeout
configurable in 50 msec steps
(maximum of 6.35 sec.)
No Same symbol timeout
Infinite Same symbol timeout
DEFAULT
*
Variable
None
Normal
Before
transmit
None
*
35