Default Settings - Metrologic MS9500 VOYAGER series Installation And User Manual

Appendix B – Default Settings
Many functions of the scanner can be "programmed" – that is, enabled
or disabled. The scanner is shipped from the factory programmed to a
set of default conditions. The default parameter of the scanner has an
asterisk (*) in the charts on the following pages. If an asterisk is not in
the default column then the default setting is OFF or DISABLED. Every
communication does not support every parameter. If the
communication supports a parameter listed in the charts on the following
pages, a check mark will appear.
PARAMETER DEFAULT
Normal Scan Mode *
Continuous Scan Mode
Blinky Scan
Continuous Blinky Scan
Custom (one shot) Scan
Long-Range In-Stand *
Short-Range In-Stand
Long-Range Out-of-Stand *
Short-Range Out-of-
Stand
CodeGate Active In-
Stand
CodeGate Inactive In-
Stand *
CodeGate Active Out-of
Stand *
CodeGate Inactive Out-of
Stand
UPC/EAN *
Code 128 *
Code 93 *
Codabar *
Interleaved 2 of 5 (ITF) *
MOD 10 check on ITF
Code 11
Code 39 *
Full ASCII Code 39
31
LIGHT IBM
OCIA RS-232 KBW
PEN 46XX