TurboChef ENCORE Service Manual page 85

Figure
Item description
Reference #
1 blower Motor
2 blower Motor Speed Controller
3 bracket, bMSC
4 bracket, Catalytic Converter (qty 2) ENC-1148
5 bracket, Solid State Relay
6 Catalytic Converter
7 Clip, bMSC bracket (x2)
8 Gasket, Heater, Top
9 Heater, bottom
10 Heater, Top
11 Holder, Catalytic Converter
12 Jetplate, bottom
13 Relay, Solid State (k4/k5 - Heaters) 101286
14 RTd, Cook Cavity, 3" (x2)
15 Thermostat, High-limit, 300°C
16 vane, Turning
4
11
A
To remove the catalytic converter:
1. Ensure the oven cavity is completely cool.
2. remove the screws marked "A" and the catalytic converter
will drop beneath the holder.
3. Maneuver the catalytic converter beneath the bottom heater.
4. Lift the bottom heater and remove the catalytic converter.
Item Part Number Fastener description
NGC-1025
CON-3010
HHb-8268
ENC-1102
ENC-1147
HHb-8269
NGC-1043
ENC-3002
100661
ENC-1145
ENC-1066
HHC-6517-2
102075
ENC-1228
6
A
Nut, 1/4 - 20, Serr Hex Flange, Plated
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 1)
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 4)
Screw, #8 x 3/8, Ph Mod Truss Hd, Cres
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 2)
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 4)
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 2 each)
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 10)
Retaining Ring, .750" Id, SS, Series SH
Washer, Shim, .752" x 1.12" x .033"
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 10)
Screw, #8 x 3/8, Ph Mod Truss Hd, Cres
None
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 2)
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688 (qty 2 / heater)
Screw, M4 x 0.7 x 8, PPHd, Int Tooth, SS
Screw, #8 x 1/2, Serr Ph Truss Hd, Sheet Mtl 101688
14
Fastener Part Number
100906 (qty 6)
101682 (1 per)
101312 (qty 2)
102449 (qty 2)
101682 (qty 11)
None
101672 (qty 2)
16
9
12
A-5