TurboChef ENCORE Service Manual page 18

6 dAIlY MAINTENANCE
A
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Step 6, Continued: Clean the Oven Cavity
Do NoT apply excessive pressure to the waveguide covers (A), located on
each side of the cavity.
• F or stubborn stains, sparingly spray Oven Cleaner on the stain.
• Allow the Oven Cleaner to penetrate the stain for five minutes, then wipe clean.
Do NoT use a hose or water jet for cleaning.
Step 7: Wipe down the Oven Cavity
• Wipe down the oven cavity with a damp towel.
• Dry the oven cavity with a dry towel.
Step 8: Clean and dry the Oven door
• Clean the oven door with Oven Cleaner and a nylon scrub pad.
• Wipe the oven door with a damp towel.
• Dry the oven door with a dry towel.
Step 9: Apply TurboChef ® Oven Guard
• Spray TurboChef ® Oven Guard onto a dry towel.
• Wipe the cavity walls and the inside of the oven door.
Do NoT spray oven Guard into the oven or apply to the heating element.
Step 10: Reinstall Components
• Reinstall the jetplate and the wire rack.
Do NoT operate the oven without the bottom jetplate installed. Doing so may
damage the oven.
• Close the oven door.
• Reinstall the filter, or replace it with a new one if the mesh is deteriorated,
has large openings, or has started to dislodge from the frame.
Step 11: Clean the Oven Exterior
• Wipe the oven exterior with a damp towel.
• Remove the panel beneath the door, remove any large food particles from the panel,
and wipe it with a damp towel.
• Reinstall the panel beneath the door.
Do NoT spray chemicals into any openings, such as the louvers on the side
panels or the rear vent catalyst housing.
• The oven is ready to turn on.