Replacing The Tub; Replacing The Base - Electrolux DIVA Series Service Manual

Replacing the tub

8
(a) From inside the tub, remove the following:
- Lower basket
- Upper basket
- Wheel guides for the upper basket
- Steam venting ring/sealing ring
- Softening unit cap and ring/sealing ring
- Latch cover
- Drain filter
- Washing filter
- Lower spray arm
- Spray arm support column
- Internal feed manifold
(b) From outside the tub, remove the following:
- Upper front cross-member
- Upper rear cross-member
- Upper basket wheel supports
- Door hinge springs
- Door hinges
- Drying duct/fan

Replacing the base

9
(a) Remove any residual water from the
sump by suction so that it does not flow
into the tub and the pressure switch
tubes when the appliance is laid flat.
(b) Remove the following:
- Worktop (free-standing versions)
- Plinth (free-standing versions)
- Foot support
- Front panel
- Lower cross-member
- Lateral panels
- Adjustable feet
(c) Lay the appliance on the rear panel.
(d) Remove the following from the base:
- Adjustable central
versions only)
- Bottom panel (if featured)
- Anti-flooding device (if featured)
- Washing motor capacitor
- Suppressor (if featured)
- Fill solenoid valve
SOI/TD
rear foot (built-in
23/23
(c) Remove the following:
- Worktop (free-standing versions)
- Door assembly
- Plinth (free-standing versions)
- Foot support
- Lower cross-member
- Lateral panels
(d) From inside the tub, remove the two
screws which secure the sump.
(e) Remove the six screws which secure the
hinge uprights to the base.
(f) Remove the two screws which secure the
rear uprights to the base and remove the
uprights.
(g) Lift the tub assembly and remove from
the base.
(e) Detach the rubber
supports.
(f) Remove the screws which secure the
front and rear uprights.
(g) Detach the clamps in the rear section,
which secure the uprights.
(h) Pull the base outwards (towards you).
washing motor
599 37 44-27