Sharp SF-2040 Service Manual page 46

This completes the staple sorter installation.
If staples have become jammed.
1. Remove the stapler unit.
Open the stapler cover and remove the mounting screw securing the
unit in place.
Next, remove the staple unit.
2. Open the stapling section.
Open the stapling section by pushing up on the stapling plate while
pressing on the stapling section release lever.
Stapling section release lever
3. Remove the jammed staples.
Remove the jammed staples with the supplied tool as shown in the
figure.
* This tool can be found on the inside of the staple unit cover.
4. Close the stapling section.
Press down on the stapling plate and return it to its original position.
Next, return the stapling section release lever to its original position.
Stapling section
release lever
Stapling plate
Tool
Stapling plate
5. Reinstall the staple unit.
Reinstall the staple unit in its original location using the mounting
screw to secure it in place.
Then close the stapler cover.
Staple cover
6. Confirm that papers are stapled correctly.
Place a set of papers in the 2nd bin (below the non-sort bin), check
the stapling location, and then press the manual staple key when it
lights up.
Next, remove the papers that were placed in the 2nd bin and confirm
that they have been stapled correctly.
At this time, if the papers still have not been stapled, repeat this
procedure once again.
Copy papers
Stapling location
Copy papers
This completes the staple sorter installation.
5 – 18
Staple unit
Mounting screw
Copier