Sharp SF-2040 Service Manual page 44

9. Attach the sorter connectors.
Loosely screw in one of the two supplied bracket screws in the posi-
tion shown in the figure.
Hook the bottom of the bracket in place over this screw, then insert
the other screw into the top of the bracket and tighten both screws
securely.
[A] Disconnect the 6-pin and 10-pin connectors from the main
copier unit.
[B] Connect the sorter's 6-pin and 10-pin connectors to the copier's
6-pin and 10-pin connectors. Then insert the clasp of the tie
band into the hole on the bottom of the mounting plate for the
circuit board.
•
Step [A] is only required for models SF-2025 and SF-2030.
Bracket
screws
6-pin
connector
10-pin connector
10. Reattach the rear cabinet panel.
Reattach the rear cabinet panel in its original position with the mount-
ing screws.
Mounting
screws
Rear cabinet
panel
Mounting screws
11. Affix the stapling location labels.
Affix the stapling location labels to the copier and RADF as shown in
the figure.
Copier
Bracket screws
Bracket
Tie band
RADF
12. Affix the green label.
Lifting up on the staple sorter's release lever, separate the sorter from
the copier.
Next, affix the green label to the paper output section handle as
shown in the figure.
Holding the staple sorter's release lever, return the sorter to its
original position. At this time, confirm that the staple sorter locks
securely into place beside the copier.
Staple sorter
Plug the copier's power cord into an electric outlet,
switch on the power, and then perform the
following procedure.
13. Set the mode.
•
Perform the following key operations on the copier to set the
mode.
C 0 /
Performing the above operation will cause the current setting to
be displayed.
•
If only the SF-S53 is being set, continue by performing the follow-
ing key operation to complete the mode setting.
1 0 /
5 – 16
Green label
Paper output section handle
2 6
0 / 1