Regency Orbit Owner's Manual page 6

I F
NSTALLING THE AN
A B
TTACHING THE LADES
1. Remove fan' s top housing (Fig. 2) by removing 6 screws holding it to the mounting collar. NOTE: 3 large screws,
3 small screws.
2. Insert blades through slots in side of fan motor and align with 5 holes. (If holes do not align, the blade is upside
down.) Blades fit very snugly – be careful! (Fig. 3)
3. Start blade screw with fiber washer in each of the 5 holes. DO NOT TIGHTEN UNTIL ALL 5 ARE STARTED.
Repeat for other blades.
4. Tighten all 15 blade screws evenly and securely to ensure quiet, wobble-free operation of your fan.
5. Replace top housing removed in step 1 above using 6 screws. NOTE: 3 small screws go into slotted holes, 3 large
screws go into round holes. MAKE SURE REVERSING SWITCH IS ACCESSIBLE THROUGH SLOT IN TOP
HOUSING. If it is not, rotate top housing
housing during this step. (Fig. 3)
:
⁄ turn so switch is accessible. CAUTION: Be careful not to bend top
1
3
5