Regency Orbit Owner's Manual page 11

E C
LECTRICAL
3. Push all connected wires up into junction box.
4. Lay the black antenna wire on top of the receiver and slide the receiver in the mounting bracket (Fig. 4).
5. Reinstall the canopy on the mounting bracket.
6. Operating transmitter:
A. Install 9 volt battery (not included). To prevent damage to transmitter, remove the battery if not used for long
periods of time.
B. Store the transmitter away from excess heat or humidity.
C. This remote control unit is equipped with 16 code combinations to prevent possible interference from or to
other remote units such as garage door openers, car alarms or security systems. If you find that your fan and
light kit go on and off without using your remote control, simply change the combination code in your trans-
mitter and receiver.
D. Operation buttons on the transmitter:
HI - for fan high speed
MED - for fan medium speed
LOW - for fan low speed
OFF - for fan speed off
LIGHT - for light brightness and off
• The light function is controlled by pressing the light button. Hold button down to increase or decrease
light. Tap button quickly to turn light off or on.
• Keep pressing the button for more than one second, the light becomes dimmer and varies cyclically from
dim to bright and back again.
• The light button has auto return so it will stay at the same brightness as the last time it was turned off.
(R
ONNECTIONS
C
EMOTE ONTROL
10
) C .
ONT